1. Home
  2. Programs
  3. Engineering Services (DES)
  4. Authorized Materials Lists (AML)
  5. Prestress/Post-Tensioning Strand Systems

Prestress/Post-Tensioning Strand Systems

VSL

E5-19

Last edit date: 3/20/2024

GENERAL
Bar or Tendon Size Strand Diamter Ultimate (kips) Concrete Strength(psi) PJack (kips)
19 1/2" 784.7 N/A 589

WEDGES
Wedges Length Material Wedge Parts Wedge Angle Wedge Inside DiameterBABA Act Information*
1.570" AISI 86L20 Rc 59-62 7° Unconfirmed

ANCHOR HEADS
Anchor Heads Size Material Authorization DateBABA Act Information*
7" Ø x 2.95" C 1050 HR12/5/1975Unconfirmed
7" Ø x 2.95" ASTM A-536 Gr 80-55-066/22/1981Unconfirmed
Wedge hole angle: 7°
Wedge hole diameter: 1.035"
Strand hole diameter: 0.57"

BEARING PLATES
Bearing Plates Size Material Authorization DateBABA Act Information*
13 1/2" SQUARE x 1 3/4" ASTM A-36 . 42 KSI (Min yield )Unconfirmed
Bearing hole diameter: 5.315"
Spiral size and turns:

TRUMPETS
Trumpets Size Material Authorization DateBABA Act Information*
22" 16 GageUnconfirmed

DUCTS
Ducts Size Material Authorization DateBABA Act Information*
3 1/4" O.D. Unconfirmed

SPIRAL
-

Caltrans contact: Jim Ma, Concrete Committee Chair, jim.ma@dot.ca.gov

*As attested to by the supplier as of April 14, 2026 per definition in 2 CFR 184 and 23 CFR 635.410. Stakeholders should use this information in conjunction with corresponding Caltrans special provision section 6-1.04 to understand applicable requirement for the project.

The California Department of Transportation (Caltrans) is implementing statutory changes required by the Bipartisan Infrastructure Law -Build America, Buy America Act (BABA), as outlined in 2 CFR 184 and 23 CFR 635.410.

https://www.fhwa.dot.gov/construction/cqit/buyam.cfm